Login

MATERIAL LIST GENERATOR

PROJECT PAGE

1: PROJECT DETAILS

2: MEASUREMENTS

LINEAR FEET/SQUARES
1. Base Roof Squares
2. Waste
3. Total Roof Squares
4. Ridges(L-ft)
5. Hips(L-ft)
6. Valleys(L-ft)
7. Rakes (L-ft)
8. Eaves/Starter
9. Drip Edge
10. Parapet Walls
11. Flashing
12. Step Flashing

3: INSTALL METHOD, PANEL PROFILE & COLOR

Direct (Cut & Tuck)



Direct (Cut & Bend)

2x2 battens on Ridges, Rakes, & Hips to install Cap Shake or Mission.




Batten (Cut & Bend)

2x2 Panel battens over full roof & on Ridges, Rakes, & Hips to install Cap Shake or Mission.



Instructions:

  • Step-1 Enter your PROJECT DETAILS. Use the ‘Tab’ key to move to the next input line or box.
  • Step-2 Enter the Project Roof MEASUREMENTS. Use the ‘Tab’ key to move to the next box.
  • Step-3 Choose the INSTALL Type, Unified Steel PRODUCT and COLOR you want the MLG to calculate.
  • NOTE: You can save each job for later access by clicking "Save Project".
  • GENERATE Materials List (MLG) will take you to a breakdown of the required products.

Calculations Used

Legal Disclaimer:

This Estimate Sheet is provided on an "AS IS" basis for customer convenience and should be used only as a guide. Westlake Royal Roofing Solutions makes no guarantee of completeness, accuracy, timeliness or of the results obtained from the use of this Estimate Sheet, and it makes no warranty of any kind, express or implied, including, but not limited to warranties of performance, merchantability and fitness for a particular purpose. While reasonable efforts have been taken to ensure the accuracy of the calculations and results from the Estimate Sheet, in no event will Westlake Royal Roofing Solutions, its subsidiaries or affiliates, or the agents or employees thereof be liable for any decision made or action taken in reliance on the information in the Estimate Sheet. Estimating is best done by construction professionals with a clear understanding of the engineering and construction requirements of a particular project.

Loading...